News Detail
Home / Blog / The Basics of a Sand Pump Pool Filter

The Basics of a Sand Pump Pool Filter

Views: 0     Author: Site Editor     Publish Time: 2023-02-14      Origin: Site

A sand filter with pump is an effective and efficient way to filter your swimming pool water. It can last for years if cared for and maintained properly. The sand in a sand filter allows the water to pass through it with ease, but larger particles are unable to pass through it. As the sand is used, its rough surface gradually smoothes out as it is worn down over time.

As a result, it becomes increasingly difficult to capture larger particles and a pressure gauge will start to indicate the need to backwash the filter. A backwash is an easy cleaning method that reverses the water's flow and expels any dirt and debris into a drain.

If you're looking for a sand filter with pump that can handle a high flow rate and has an easy-to-read pressure gauge, Our sand filter with pump is an excellent choice.

Whether you're installing an in-ground pool or an above-ground pool, a sand filter pump will improve water circulation and filtration. It's a simple, inexpensive and reliable solution for cleaning your swimming pool.

A sand filter pump is made up of sand inside a canister. The sand acts as an effective filtration medium, trapping and stopping most debris and impurities from your pool.Particles as small as 20 microns in size will be captured by a sand filter. These include leaves, dust, bugs, and even larger objects like twigs.The filter canister is filled with sand, which is a natural material that's resistant to breaking down. The sand can absorb more than 90% of the debris and impurities from your pool, leaving only clean water at the end of each cycle.

Sand filter is the oldest and most common type of pool filter. It is also the cheapest to run, use and maintain.A sand pump filter uses an internal canister filled with sand and a pump to move water through the sand. This process gently exfoliates the sand, trapping and removing tiny debris as the water flows through it.

Maintenance of a sand filter is easy and inexpensive, as it requires only regular backwashing. This will remove any built-up dirt and help alleviate pressure on the gauge at the top of the sand canister.

The easiest way to backwash a sand filter is to turn the valve to “rinse” and then pour sand filter cleaner into the strainer lid. This should take 3-5 minutes to complete.Another way to backwash a sand pump filter is to change the sand inside the tank, which is pretty easy. You can either replace the sand by hand or buy replacement cartridges for the sand.

sand filter with pump

sand filter with pump

sand filter pump

sand pump filter